Panasonic AG-CX350

– 95 –
Chapter 4 Operation — Menu settings
[CLIP NAME]
[CAM INDEX]
Sets the CAM INDEX used in the name for the MOV format le to be recorded. Set one upper case alphabetical character. This is used as a value to be
stored in the volume label of the memory card.
The items that can be set are as follows.
f [A]…[Z]
(Factory setting: [A])
[NEXT CARD COUNT]
Sets the CARD COUNT used in the name for the MOV format le to be recorded. In the following cases, the setting value in [NEXT CARD COUNT] is
stored in the volume label of the memory card together with the [CAM INDEX] setting value as CARD COUNT. Also, the setting value will increase one
after storing. ([001] returns after [999])
f When formatted the memory card
f When recorded to the memory card where CARD COUNT is not stored in the volume label
The items that can be set are as follows.
f [001]…[999]
(Factory setting: [001])
[FILE SPLIT]
Selects the split method of the le in P2 format to be recorded.
The items that can be selected are as follows.
f [ONE FILE], [SPLIT]
(Factory setting: [SPLIT])
@@
NOTE
t When using a microP2 card with 32 GB or less, it is split every 4 GB regardless of selected item.
t A clip of 4 GB or more recorded by selecting [ONE FILE] cannot be copied to a microP2 card with 32 GB or less.
t The setting is xed to [SPLIT] when recording format is AVC-Intra 200/AVC-Intra 100/AVC-Intra 50.
[2 SLOTS FUNC.]
Sets the recording function that uses two memory cards.
[OFF] Does not set.
[RELAY REC] Sets to the relay recording.
[SIMUL REC] Sets to the simultaneous recording.
[BACKGR REC] Sets to the background recording.
(Factory setting: [RELAY REC])
@@
NOTE
t For the combinations and restrictions of the settings, refer to “Recording function that cannot be used simultaneously” (page 204).
[PRE REC]
Sets whether to perform pre-recording.
The pre-recording time varies depending on the setting of the [SYSTEM] menu → [REC FORMAT].
[ON] Performs the pre-recording.
The pre-recording time is as follows.
f When [FILE FORMAT] is set to [P2]: Approximately 3 seconds
f When [FILE FORMAT] is set to [MOV], and [REC FORMAT] is set to [2160-29.97p/422ALL-I 400M], [2160-25.00p/422ALL-I
400M], or [2160-23.98p/422ALL-I 400M]: Approximately 3 seconds
f When [FILE FORMAT] is set to [MOV], and [REC FORMAT] is set to [2160-59.94p/HEVC LongGOP 200M], [2160-59.94p/
HEVC LongGOP 100M], [2160-59.94p/420LongGOP 150M], [2160-50.00p/HEVC LongGOP 200M], [2160-50.00p/HEVC
LongGOP 100M], [2160-50.00p/420LongGOP 150M], [2160-29.97p/HEVC LongGOP 150M], [2160-29.97p/422LongGOP
150M], [2160-29.97p/420LongGOP 100M], [2160-25.00p/HEVC LongGOP 150M], [2160-25.00p/422LongGOP 150M],
[2160-25.00p/420LongGOP100M], [2160-23.98p/HEVC LongGOP 150M], [2160-23.98p/422LongGOP 150M], or
[2160-23.98p/420LongGOP 100M]: Approximately 5 seconds
f When set to other than above: Approximately 10 seconds
[OFF] Does not perform the pre-recording.
(Factory setting: [OFF])
@@
NOTE
t For the combinations and restrictions of the settings, refer to “Recording function that cannot be used simultaneously” (page 204).
[REC FUNCTION]
[REC MODE]
Selects the recording mode.