– 96 –
Chapter 4 Operation — Menu settings
[NORMAL] Performs the standard recording.
[INTERVAL] Performs the interval recording. (A function to repeatedly perform the operation of one frame recording in set time interval.)
(Factory setting: [NORMAL])
@@
NOTE
t For the combinations and restrictions of the settings, refer to “Recording function that cannot be used simultaneously” (page 204).
[REC MODE HOLD]
Selects whether to hold [REC MODE] settings.
[ON] Holds the settings.
[OFF] Does not hold the settings. It will always be [NORMAL] the next time when the power is turned on.
(Factory setting: [OFF])
[INTERVAL TIME]
Sets the interval duration for interval recording.
The items that can be set are as follows.
f [1s], [2s], [5s], [10s], [30s], [1min], [5min], [10min]
(Factory setting: [5min])
[TC/UB]
[TC PRESET]
Sets the default value of the time code to record.
Hour [00]…[23]
Minute [00]…[59]
Second [00]…[59]
Frame [00] … [23] (when [23.98p])
[00] … [24] (when [50.00i], [50.00p], or [25.00p] is set)
[00] … [29] (when [59.94i], [59.94p], or [29.97p] is set)
(Factory setting: [00]) (each item)
[UB PRESET]
Sets user bits.
Enabled only when [USER] is selected in [UB MODE] of [TC/UB].
Each digit can be set in following range.
f [00]…[FF]
(Factory setting: [00])
[FREE/REC RUN]
Sets the operation mode to advance the time code generator.
[FREE RUN] Advances regardless of the operation mode.
[REC RUN] Advances only while recording.
(Factory setting: [REC RUN])
@@
NOTE
t The setting is xed to [REC RUN] when the [SCENE FILE] menu → [VFR] → [ON] is set.
t The setting is xed to [REC RUN] when the [SYSTEM] menu → [SUPER SLOW] → [ON] is set.
t The setting is xed to [FREE RUN] when the [RECORDING] menu → [PRE REC] → [ON] is set.
t The setting is xed to [FREE RUN] when the [RECORDING] menu → [2 SLOTS FUNC.] → [BACKGR REC] is set.
t The setting is xed to [REC RUN] when the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL] is set.
[DF/NDF]
Sets the count method for the time code generator.
Enabled only when the recording frame frequency of the [SYSTEM] menu → [REC FORMAT] is set to 59.94i/59.94p/29.97p.
[DF] Uses the drop frame mode.
[NDF] Uses the non-drop frame mode.
(Factory setting: [DF])
@@
NOTE
t The setting is xed to [NDF] when the [RECORDING] menu → [REC FUNCTION] → [REC MODE] → [INTERVAL] is set.
[UB MODE]
Selects the user bits mode. User bits information is recorded in the clip. Also, it is output as LTC UB, VITC UB of the SDI signal.
[FRAME RATE] Selects the image information (such as frame rate) of the camera.
[USER] Selects the user bits set in [UB PRESET].
To Next Page
Loading...
