Panasonic AG-DVX200 - Page 19

19
USER SWITCH <continued>
Note: Items marked  will not function when OUTPUT BIT item is set to “4:2:2 10bit”.
The following table shows all functions that can be assigned to the USER buttons.
Menu item
Description
CAPTURE
Create a still image from camera image or recorded video.
EVF/LCD DETAIL
Make focusing easier by enhancing the subject’s edge on the viewfinder
and built-in LCD monitor.
The level of this enhancement and the frequency can be set using the
“EVF/LCD PEAK LEVEL” and “EVF/LCD PEAK FREQ.” items of the
DISP menu.
IR REC
Turn ON/OFF the Infrared shooting mode.
LEVEL GAUGE
Display a level gauge on the viewfinder for the horizontal and vertical
axis’. Inclinations can be indicated up to approx. 45 degrees in the
horizontal, and up to approx. 10 degrees in the vertical directions.
BACK GROUND
Start or pause the recording in slot No.2 when the “Background record
function” is enabled.
FLASH BAND
Turn ON/OFF the image compensation function, which allows removing
flash-bands from the image.
PRE-REC
Turn ON/OFF the pre-record mode. This mode allows the camera to start
recording video and audio approx. 4 sec (in MOV/MP4 mode, 3 sec in the
AVCHD mode) before the REC/PAUSE button is pressed.
WFM
Display the Waveform or Vector scope on the built-in LCD monitor.
Open the “WFM TYPE” item of the SWITCH SETTING menu to select the
item (Waveform or Vector scope).
FAST ZOOM
Increase servo zoom speed.
Note: When this feature is turned ON, motor’s operation sound becomes
louder, and may be audible and recorded.
EVF ON/OFF
Turn ON/OFF the EVF display.
A.IRIS LEVEL
Turn ON/OFF the level adjustment mode for auto iris.
ZEBRA
Turn ON/OFF the ZEBRA indicator.
O.I.S
Turn ON/OFF the optical image stabilizer.
SCENE FILE
Save or load scene file data between an SD memory card and the
camera.
AUTO REC
Turn ON/OFF sending the embedded REC-Start/-Stop signal to external
recorders connected via SDI OUT.
AF AREA
Adjust the size of window where auto focus (AF) is enabled via jog dial.
VFR
Turn ON/OFF variable frame rate mode.
FOCUS MACRO
Turn ON/OFF the macro mode. With macro mode ON, focus adjustable
range at Wide-end is from 10cm to infinity. (With macro mode OFF, from
1meter to infinity.)
i. ZOOM
Turn ON/OFF the “i.Zoom” mode which allows the camera to magnify the
image (electronically) up to x20 at the Tele-end. This mode can only be
enabled when resolution setting is 1920x1080 or lower.
LOG VIEW ASSIST
Temporarily show the image based on Rec.709 color space when the
V-Log L mode is enabled.
LCD/EVF OUTPUT
Select the display device. (Always displayed on either Built-in LCD
monitor or EVF, or automatically switched by the eyepiece sensor)
3. MENU settings