5-72
5
6. Remove the screws (M6 x2 locations: Fig. 6) fixing the fan motor.
It is recommended that a nutdriver (8mm) be used.
7. Remove the
bracket (Fig. 6) and then remove the fan and fan motor (Fig. 7).
8. Loosen the fixed screw with a hexagon wrench (3mm, over 100mm in length) and remove the fan.
9. Remove the rubber attached to the wiring of the fan motor (Fig. 9).
1. For installation, reverse the procedure above.
2. Fine tune so that the fan can be positioned in the center of the fan casing.
Bracket
Fan motor
Fixed screw
Fan
Hexagon wrench
Rubber
Screws (M6)
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Installing Fan Motor
SM830231-02īSingleī꬧å·.indbīīī72SM830231-02īSingleī꬧å·.indbīīī72 2014/09/11īīī15:44:272014/09/11īīī15:44:27
To Next Page
Loading...
Need help?
General
