9.11. DVD-RAM DRIVE / DIGITAL
P.C.B. MODULE
CAUTION:
The DVD-RAM Drive and the Digital P.C.B. have
to be replaced together as one Module.
If the Module is changed the DVD-RAM Drive has to
be re-aligned because the aligment data for the
DVD-RAM Drive is stored in the Digital P.C.B.
1. Remove 3 Screws.
2. Lift up DVD-RAM Drive slightly.
3. Disconnect FFC from Digital P.C.B.
4. Remove 4 Screws and DVD Angle.
5. Disconnect FFC.
6. Remove 4 Screws from Digital P.C.B.
7. Pay attention while pulling out Digital P.C.B.
to disconnect Connector (A).
32
DMR-EZ45VEB
To Next Page
Loading...
