28
RQT9127
Copying from an external device
[RAM] [-R] [-RW‹V›] [+R] [+RW]
[RAM] When the “DV Auto Rec” function is used, programmes are
recorded as a title while at the same time chapters are created at
each break in the images and the playlist is created automatically.
≥Turn off the unit and DV equipment before connecting.
≥Select the type of audio recording from “Audio Mode for DV Input”
in the Setup menu (➡ 61).
≥When recording from DV equipment (e.g., digital video camcorder),
you can record audio/video recordings from DV tape only.
Preparation
1 Turn off the main unit and DV equipment, then connect the
equipment with the unit’s DV input terminal (➡ above).
2 Turn on the main unit.
≥When the output signal from the external equipment is NTSC,
change the “TV System” to “NTSC” in the Setup menu (➡ 62).
1 Turn on the DV equipment, and pause
play at the point you want recording to
start.
The following screen appears.
≥When the screen is not displayed
2 Press [2, 1] to select “Rec to DVD”
and press [OK].
3 Press [REC MODE] to select the
recording mode.
4 Press [2, 1] to select “Rec” and
press [OK].
Recording starts.
When recording finishes
The confirmation screen appears. Press [OK] to finish DV automatic
recording.
To stop recording
Press [∫].
[Note]
≥If it becomes time for a timer recording to start while copying, the
recording will start and the copying will stop.
≥If video is copied from another piece of equipment to this unit, then
the video quality will be degraded.
≥External DV cannot be recorded to VHS.
≥Only one piece of DV equipment (e.g., digital video camcorder) can
be connected to the unit via the DV input terminal.
≥
It is not possible to operate the unit from the connected DV equipment.
≥The DV input on this unit is for use with DV equipment only. (It
cannot be connected to a computer, etc.)
≥The DV equipment name may not be shown correctly.
≥Depending on the DV equipment, the images or audio may not be
input properly.
≥The date and time information on the tape of the DV equipment will
not be recorded.
≥You cannot record and play simultaneously.
DV automatic recording (DV Auto Rec)
S VIDEO
IN 2
VIDEO
/MONO
AUDIO
R
L
S VIDEO
VIDEO
/MONO
AUDIO
R
L
AV2 IN
DRIVE SELECT
REC
CH
OPEN/CLOSE
EJECT
COPYING
This unit
DV equipment
DV cable
(IEEE 1394,
4-pin)
After performing step 1
1 Press [DRIVE SELECT] to select the DVD drive.
2 Press [FUNCTION MENU].
3 Press [3, 4] to select “To Others” and press [OK].
4 Press [3, 4] to select “DV Auto Rec” and press [OK].
➡ Go to step 3 (➡below)
If the DV automatic recording function does not work properly,
check the connections and DV equipment settings, and turn the
unit off and back on.
If that does not work, follow the instructions for manual
recording (➡ 27).
DV Auto Rec
Rec to DVD Cancel
DV unit is connected.
Record from the DV unit?
OK
RETURN
SELECT
DMREZ48VGN-RQT9127-L_eng.book 28 ページ ２００８年５月７日 水曜日 午前９時２８分
To Next Page
Loading...
