Panasonic EYFR03 - Page 49

EYFR03 User Manual 49 of 110 v1.6.0
Chapter 4: 20 January 2020
3. Qualifier Name
This command sets the Qualifier Name of the unit.
Data: up to 25 characters
Example:
*%03%air - bag%*
This bar code would set the Qualifier Name of the unit to “air - bag”.
4. VIN
This command sets the VIN or Identifier part 1 (VIN characters 1-25) reported by the unit in
tightening result messages, the ACOP MID 0052 Vehicle ID Number, and the ACOP MID 0152
Multiple identifier and result parts notifications.
Data: up to 25 characters
Example:
*%04%VIN1234567%*
As mentioned above, a bar code is assumed to be a VIN number if the data is not in the
command format. As such, the same VIN could be provided as:
*VIN1234567*
5. Start Job
This command instructs the unit to select a job. Any other running parameter, group, or job will
be stopped before starting the new job.
Data: number of up to 3 digits specifying the job number to run (1-100)
Example:
*%05%32%*
This bar code would instruct the unit to start job number 32.
6. Identifier part 2
This command sets the Identifier part 2 (VIN characters 26-50) reported by the unit in tightening
result messages and the ACOP MID 0152 Multiple identifier and result parts notifications.
Data: up to 25 characters
Example:
*%06%B23FJ9S3%*
7. Identifier part 3
This command sets the Identifier part 3 (VIN characters 51-75) reported by the unit in tightening
result messages and the ACOP MID 0152 Multiple identifier and result parts notifications.
Data: up to 25 characters