General Specifications FP2 Multi-wire Link Unit
1-16
1.4 Confirming the Design Contents
1.4 Confirming the Design Contents
1.4.1 Confirming the Current Consumption
Whenthesystem architecture is configured, the internalcurrent consumptionof the Mul-
ti-wire link unit(witha 5 V DCpower supply)shouldbe kept within therangeof thepower
supply unit, taking into consideration the conditions under which other units are used.
Product name Order number Current consumption (at 5 V DC)
FP2 Multi-wire link unit
FP2-MW 220mA or less
For information on the internal current consumption of other units, refer to the FP2 Hard-
ware Manual and the manuals for the other units.
1.4.2 Confirming I/O Allocations
When a FP2 Multi-wire link unit is installed, it automatically occupies 16SE (16 points).
This can be changed to 0SE, however, using the NPST-GR programming software.
To Next Page
Loading...
