Panasonic FP2

Parts and Its FunctionsFP2 Multi-wire Link Unit
2-7
2.2 Switch Settings
2.2 Switch Settings
2.2.1 Station Number Selector
These are used to set the local station number in the W and W2 modes.
(Not used in the F mode.)
Align the arrow with the number to be used. (The illustration shows an example in which the
arrow points to 07 (No. 7).)
m
Upper digit position
m
Lower digit position
MEWNET mode Description
Effective
range
01 to 32 (decimal)
Specifying a number out of this range will cause a station number
setting error to occur.
W mode
Operation
The station number can be changed while in operation. If the
number was changed while in operation, the setting becomes
effective in that instant. Be aware, however, that if the station
number following the change overlaps that of another unit, an error
will occur.
W2
mode
Effective
range
01 to 64 (decimal)
Specifying a number out of this range will cause a station number
setting error to occur.
(Note: Station numbers 1 to 64 can be used, but the maximum
number of slave stations that can actually be connected to the PC
link is 32.)
mo
d
e
Operation
The station number cannot be changed while in operation. The
power should be turned off before changing the station number. The
setting will be effective the next time that the power is turned on. If
the setting is changed with the power on, be aware that the setting
in effect when the power was turned on will remain effective.