Panasonic FP2 - Page 35

Parts and Its FunctionsFP2 Multi-wire Link Unit
2-9
2.2 Switch Settings
2.2.3 Mode Selector Switches (2)
(Rear)
Communication speed(W2 mode only)
Operation mode(W/W2/F mode selection)
When the unit is shipped from the factory, all switches are set to the ”OFF” position.
The contents of the mode selector switches (2) are indicated by the status indicator LEDs.
No
Item
Setting contents
N
o.
It
em
W mode W2 mode F mode
1
O
p
eration mode
ONOFF
ONOFF
ONOFF
2
Operation
mode
setting
ON
OFF
3
Communication
speed (
*
Note 1)
500kbps (fixed)
500kbps
ONOFF
250kbps
ONOFF
500kbps (fixed)
4
——————— This should always be secured at “OFF” when being used.
.
Notes
D
(
*
1):When the W2 mode is set, 500 kbps and 250 kbps setting
units should not be mixed in the same network.
D
The settings of the mode selector switches (1) and (2) should
always be changed with the power off. The setting will be ef-
fective the next time that the power is turned on. (If the setting
is changed with the power on, be aware that the setting in ef-
fect when the power was turned on will remain effective.)
D
Only the settings of the mode selector switches (1) No. 7 and
No. 8 (terminal station settings) will be effective at the instant
that they are changed.