The microphone volume is small.
Increase the volume of the microphone according to the following steps.:
1.
Touch (All apps) - [Windows System] - [ControlPanel].
2. Touch [Hardware and Sound] - [Sound] - [Recording] - [Microphone Array] - [Prop-
erties], and then increase the volume of [Microphone Array] and/or [Microphone
Boost] in [Levels].
When signing in (e.g., resuming the com-
puter), audio is distorted.
Perform the following steps to change the audio settings to prevent audio output.
1.
Touch and hold (Speaker) on the tasktray, and touch [Sounds].
2. Remove the checkmark from [Play Windows Startup sound].
The feedback noise may occur.
To stop microphone's monitoring output.
1.
Touch (All apps) - [Windows System] - [ControlPanel].
2. Touch [Hardware and Sound] - [Sound] - [Recording] - [Microphone Array] - [Prop-
erties], and then remove a check mark for [Listen to this device] in [Listen].
Input Characters
Cannot enter specialcharacters (ß, à, ç,
etc.) and symbols.
Use the character map.
1.
Touch (All apps) - [Windows Accessories] - [Character Map].
2. Input “Character”.
Network
<Only for modelwith LAN>
Cannot connect to a network.
Set the device [Extension Port] to [Enabled] in the [Advanced] menu of the Setup Utility.
<Only when using the Cradle with LAN>
Cannot connect to a network.
Set [Cradle USB Port] to [Enabled] in the [Advanced] menu of the Setup Utility.
Cannot check the computer's MAC
address.
Follow the steps below.
1.
Touch (Settings).
2. Touch [Network & Internet] - [Status] - [View your network properties].
Properties of each device appears.
Write down the 12-digit address (alphanumeric) that appears for “Physical address
(MAC):” rows of each devices.
The namesof each of the devices are as follows.
Device Connection name
Wireless WAN Cellular
<Only for modelwith LAN>
Wired LAN
Ethernet
Wireless LAN Wi-Fi
Bluetooth Bluetooth Network Connection
* The content displayed will vary depending on the device and model.
3.
Touch to close the window.
- 115 -
To Next Page
Loading...
