Wireless Communication (only for model with wireless LAN/Bluetooth/wireless WAN)
Cannot connect to a network.
Set the device ([Wireless LAN] / [Bluetooth] / [Wireless WAN] of [Wireless Configuration]) to
[Enabled] in the [Advanced] menu of the Setup Utility( Wireless Configuration).
Confirm the airplane mode is Off.
To turn off the airplane mode, follow the steps below.
1.
Touch (Settings) - [Network & Internet] - [Airplane mode]
*1
.
2.
Set “Airplane mode”
*1
to [Off], and then;
set “Cellular” to [On] (for wireless WAN).
set “Wi-Fi”
*1
to [On] (for wireless LAN).
set “Bluetooth” to [On] (for Bluetooth).
set “GPS” to [On] (for GPS on wireless WAN).
set “GPS/GNSS” to [On] (for dedicated GPS).
If thiscomputer cannot be connected to an IEEE802.11a network, confirm “Enabling/Disabling
the Wireless LAN Standard IEEE802.11a (802.11a)”.
Restart the computer.
Accesspoint isnot detected.
Shorten the distance between the computer and the accesspoint, and try the detection again.
Confirm the following settings:
[Wireless LAN] in the [Advanced] menu of the Setup Utility
Confirm that [WirelessLAN] of [Wireless Configuration] is set to [Enabled].
Airplane mode
*1
Confirm that Wireless LAN (Wi-Fi) is[On].
This computer uses channels 1 through 13
*2
when using IEEE802.11b/g/n. Check the channel
being used by the access point.
<Only for modelwith wireless WAN>
Cannot communicate.
Confirm the following settings:
[Wireless WAN] in the [Advanced] menu of the Setup Utility
Confirm that [WirelessWAN] of [Wireless Configuration] is set to [Enabled].
Airplane mode
*1
Confirm that Wireless WAN (Cellular) is [On].
Confirm that the SIM card is inserted correctly.
If communication is not established after proceeding with the above remedies, the wireless WAN device
may not be correctly recognized. Restart the computer.
*1 : Screen messages are explained in [English (United States)].
(Depending on the language preference, some screen messages in these instructions are different from the actual screen messages. For example,
[Flight mode]/[WiFi] may be displayed instead of [Airplane mode]/[Wi-Fi] in some language preference.)
*2 : In the case of wireless communications, the frequency band being used can be divided into segments, so that different communications can be con-
ducted on each band segment. A “Channel” refers to the individual frequencybandwidth divisions.
Display Rotation
Cannot rotate the display.
The application program currentlyrunning maynot support the image rotation. Quit the pro-
gram, and then try to rotate the image. This can ameliorate the status.
When the automaticrotation isoff, screen display does not rotate automatically.
The operations of screen do not match the
rotation angle.
The application program currentlyrunning maynot support the image rotation. Quit the pro-
gram, and then try to rotate the image. This can ameliorate the status.
Change a screen setup to landscape.
- 116 -
To Next Page
Loading...
