Panasonic GT02

9-12
Communication Parameters Settings
The example of communication settings of GT and PLC is shown below.
Setting Values for GT (Set in the configuration setting of GTWIN.)
Item
Setting
Baud Rate
19200bps
Data Length
7
Stop Bits
1
Parity Bit
Even
Setting Values for PLC
Setting for MICRO-EH
Port1
The settings for the dip switches and the special internal output are required.
Specify as follows
Item
Setting
Port type
Setting for special port
Procedure of communication control
Procedure 1 of transmission control (No unit No.)
Baud rate
19200 bps
* For the details of the method of communication setting, refer to the "EH-SIO Application Manual".