Panasonic GT02

1-18
Bit/Word Device
No.
Memo
Word
Device
Input Relay
X000000-X001FF
Specify address expression every 0
Output Relay
Y000000-Y001FF0
Specify address expression every 0
Internal Relay
M000000
-M032752
Specify address expression every 16
multiples
Latch relay
L000000-L032752
Annunciator
F000000-F032752
Edge relay
V000000-V032752
Link Relay
B000000-B007FF0
Specify address expression every 10
Special relay
SM000000-SM002032
Link special relay
SB000000-SB0007F0
Step relay
S000000-S008176
Direct access input
DX000000-DX001FFF
Direct access output
DY000000-DY001FFF
Timer(current)
TN000000-TN023087
Retentive timer(Current
value)
SN000000
-SN023087
Counter(current)
CN000000-CN023087
Data Register
D000000-D025983
Link Register
W000000-W00657F
Link special register
SW000000-SW0007FF
Index register
Z0-Z15
File Register(for block
number)
R000000
-R032767
File register(for
sequential number)
ZR000000
-ZR1042431
Special register
SD000000-SD002047
Note:
- The maximum value that can be set with the GT is described.
- The range of usable addresses differs depending on the model. For details, please consult the manual
for the PLC you will use.
- When you use a serial communication module, you will set some parameters (Slot No., Module type,
I/O points and Start address etc). Input and output relay from the start address for set points can’t be
used.
- Although "Mitsubishi MELSEC-A (Computer Link) Series" can be used, the address range is the same
as the one for "Mitsubishi MELSEC-A (Computer Link) Series".