Note
• If you need to change the advanced settings, click in [Advanced Settings].
• When [Data Transfer Notification] is [On], a message indicating the scanning process is
complete can be displayed on the LCD.
11. Click [Submit] to apply the settings, and then click [Back].
• Make sure the list has been added.
Select the job mode for push scan
• Operate the scanner as follows.
1. Press the menu button (
).
2. Use or of the cursor button to select "Function Setting".
3. Press the OK button to complete your selection.
4. Use or of the cursor button to select "Job mode".
5. Press the OK button to complete your selection.
6. Use or of the cursor button to select "Preset Scan".
7. Press the OK button to complete your selection.
Scan the documents
• Operate the scanner as follows.
1. Press the Job button ( ).
2. Use or of the cursor button to select a Preset Group.
3. Use or of the cursor button to select a Job.
4. Place the documents on the feed tray.
5. Press the Start/Stop button ( ) to start scanning.
• If [Confirm Output Path] of Preset Scan setting is enabled, the output path will be displayed on the
LCD. Confirm the output path, and then press the Start/Stop button ( ) again.
• If [Confirm Output Path] of Preset Scan setting is disabled, scanning will start.
6.4.5 Preset Scan Mode
72
To Next Page
Loading...
