Note
• When a call is received while another call is on hold, pressing and releasing the hook switch will
answer the call.
• If / LINE 1/P1 or / LINE 2/P2 key is assigned as a Line key, and a call is on hold on that line,
you can retrieve the call on hold by following the step below.
1. Press the corresponding / LINE 1/P1 or / LINE 2/P2 key.
To retrieve a call on hold at your line (For KX-HDV230)
1. Press
/ / HOLD .
2. When two or more lines are on hold, press [▲] or [▼] to select a line on hold, and then press
.
Note
• When a call is received while another call is on hold, pressing and releasing the hook switch will
answer the call.
• If a function key is assigned as a Line key, and a call is on hold on that line, you can retrieve the call
on hold by following the step below.
1. Press the corresponding function key.
3.4.3 Holding in a System Parking Zone (Call Park)
You can use this feature as a transferring feature.
When Call Park is permitted, the
soft key is displayed. However, the Call Park feature number must be
set beforehand. Also, depending on your phone system, you may need to enter a parking zone number to
retrieve a parked call. The feature depends on your phone system. Contact your administrator for further
information.
To set
1. Press
key during a conversation.
Or press an unused (LED is off) function key to which the Call Park function is assigned (KX-HDV230
only).
2. Go on-hook or press
.
To retrieve (Call Park Retrieve)
1. In standby mode, enter the Call Park Retrieve feature number.
Or press a function key in use (blue LED is slowly flashing, or red LED is slowly flashing) to which the
Call Park function is assigned (KX-HDV230 only).
2. Go off-hook.
Note
• Depending on the telephone system, the
soft key might blink to show that the line has a parked
call. In this case, you can retrieve the call by pressing the blinking
soft key. However, to retrieve
a parked call using the soft key, the Call Park Retrieve feature number must be set beforehand.
Contact your administrator for further information.
3.4.3 Holding in a System Parking Zone (Call Park)
Document Version: 2017-08 Operating Instructions 55
To Next Page
Loading...
