Panasonic KX-HDV130

4.10 Changing the System Settings
Note
• The feature depends on your phone system. Contact your administrator for further information.
To select the main item
1. In standby mode, press
Menu
.
2. Press [▲] or [▼] to select "System Settings", and then press
OK
.
3. Press [▲] or [▼] to select the main item, and then press
OK
.
Main item Sub Item
Status Line Status, Firmware Version, IP Mode, IPv4 Settings, IPv6 Settings, MAC
Address, LLDP, CDP, VLAN
Network Settings IP Mode Select, IPv4 Settings, IPv6 Settings, LLDP, CDP, VLAN, Link Speed,
Embedded Web, Network Test
System Settings Set Time & Date, Authentication, Access Code, Xsi Setting, UC Setting,
Restart, DSS Restart (KX-HDV230 only)
4.10.1 System Settings Menu Layout
Status
Sub Item Description Status
Line Status
For KX-HDV130:
Line 1–Line 2
For KX-HDV230:
Line 1–Line 6
Displays the line status. Registered
*1
/ Registering
*1
/ (NULL)
Firmware Version Displays the firmware version of the
telephone.
—
IP Mode Displays the IP network mode. IPv4 / IPv6 / IPv4&IPv6
IPv4 Settings Displays information about IPv4
settings.
IP Address
*2
Subnet Mask
*2
Default Gateway
*2
DNS
*2
IPv6 Settings Displays information about IPv6
settings.
IP Address
*3
Prefix
*4
Default Gateway
*3
DNS
*3
MAC Address Displays the MAC address of the
telephone.
—
LLDP Displays the LLDP status. On / Off
CDP Displays the CDP status. On / Off
4.10 Changing the System Settings
Document Version: 2017-08 Operating Instructions 89