Panasonic KX-HDV130

3. Talk to the party and go on-hook to end the call.
4. Go off-hook and talk to the remaining party.
*1
When a program key is assigned as a Line key, this feature is available.
Removing a Party from the Conference (For KX-HDV230)
During a conference, you can remove other parties from the conference. However, this operation is
available only during conference calls you initiate.
1. During a conference call, press
/ / HOLD .
2. Press
/ / HOLD again to show the conference parties on hold.
3. Press [▲] or [▼] to select the party to remove, and then press
OK
.
4. Talk to the party and go on-hook to end the call.
5. Press
/ / HOLD .
Ending a Conference Call
To end the conference call, go on-hook.
3.4.6 Muting the Microphone or the Handset
You can disable the microphone or the handset to consult privately with others in the room while listening to
the other party on the phone through the speaker or the handset.
To set/cancel
1. Press / MUTE/AUTO ANS .
Note
• When the icon is blinking on the LCD, Mute is on.
• During Mute, even if you switch from/to speakerphone, Mute will continue.
• During Mute, even if you connect/disconnect a headset, Mute will continue.
3.4.7 Using Call Waiting
During a conversation, if a second call arrives, you will hear a call waiting tone. You can answer the second
call by disconnecting or holding the current call. This is an optional telephone company service. You can
receive a call waiting tone and the caller's information. For details, contact your phone system dealer/service
provider.
To disconnect the current call and then talk to the new party
1. Go on-hook.
2. Go off-hook.
To hold the current call and then talk to the new party
1. Press
Answer
.
Note
• For KX-HDV130: You can also answer the call by pressing / / HOLD/MESSAGE .
• For KX-HDV230: You can also answer the call by pressing / / HOLD .
3.4.6 Muting the Microphone or the Handset
Document Version: 2017-08 Operating Instructions 57