Panasonic KX-HDV130

4.8 Setting ECO Mode
Enabling this mode reduces the amount of electricity consumed by the unit.
Note
• When ECO mode is enabled, the "Link Speed" setting changes as follows:
– Link Speed: "10M/Full"
*1
– PC port cannot be used
• When the ECO mode setting is changed, the unit will restart.
• When ECO mode is enabled,
ECO
is displayed while the unit is in standby mode.
*1
The port of the switching hub to which the unit is connected must be 10 Mbps (Fixed) / full duplex.
To set
1. In standby mode, press
Menu
.
2. Press [▲] or [▼] to select "ECO Mode"
*1
, and then press
OK
.
3. Press [▲] or [▼] to select "On"
*2
, and then press
OK
.
*1
The administrator password may be required for this setting. Contact your administrator for further information. For available
characters, see “5.2 Character Table for Administrator Password".
*2
To disable ECO mode, select "Off" (default).
4.8 Setting ECO Mode
82 Operating Instructions Document Version: 2017-08