• The Two-way Record button light, Two
-way Transfer button light or One-touch Two-way
Transfer button light shows the current status as follows:
Off: Not recording.
On: Recording the conversation.
Note
When
you record your Two-way telephone conversations, you should inform the other party
that the conversation is being recorded.
• If
all Unified Messaging system ports are busy when you try to use one of these features, you
will hear a warning tone, dial tone, or busy tone, depending on the feature you are trying to
use.
• Recording time when using these features may be limited. For more information, consult your
System Administrator.
Customising Your Phone
• 3.1.3 Customising the Buttons
Create or edit a Two-way Record button, a Two
-way Transfer button and a One-touch
Two-way Transfer button.
Assigning Your Telephone Numbers for Remote Automatic Log-in and
Toll Saver
When logging in to your mailbox remotely
(i.e., from an outside telephone) to listen to your messages, the
Remote Automatic Log-in (refer to "
Remote Access")
and Toll Saver features identify you by recognising
your telephone number (caller ID). In order to use these features, you must first store the telephone numbers
that you will use to access your mailbox remotely.
Automatic Log-in and Toll Saver may be disabled by the System Administrator for your mailbox.
To assign
PT/SLT/PS/SIP Extn./S-PS
Enter 49.
On-hook.
Log in to your mailbox.
94
1
Change telephone number 1
Change telephone number 2
Enter 1 or 2.
2
Enter 2
to accept.
2
Enter your outside telephone number
(max. 20 digits including area code if needed) and #.
outside telephone no.
If you have already set a telephone number and
wish to change it, press 1 after selecting telephone
number 1 or 2.
OR
#
To Next Page
Loading...
