1.4 During a Conversation
1.4.1 Transferring a Call (Call Transfer)
– Transferring to an Extension in the PBX
– Transferring to an Outside Party Using the PBX Service
–
Transferring a Call Using the ISDN Service (Call Transfer [CT]—by ISDN)
– Transferring to an Outside Party Using the SIP Service
• You
can transfer a held call without talking, and go on-hook even if the transferred party does
not answer the call.
If a transferred call is not answered within a specified time, it will ring at a preprogrammed
extension, if set, or at your extension again. If you are off-hook at that time, you will hear an
alarm tone. If an outside call is not answered within a specified time, it is automatically
disconnected.
• For users of non-KX-UT series SIP phones:
– Even if your telephone has a TRANSFER button, you cannot use it to transfer calls.
Please make sure to use the HOLD button.
– The transfer operation for SIP extension users may differ from the steps in this section,
and may vary depending on the type of telephone being used.
– Blind Transfer
Blind Transfer may be available on your phone. For details about using Blind Transfer,
refer to the documentation for your SIP phone. (This feature is not available when
transferring to an outside party using the SIP service.)
Transferring to an Extension in the PBX
To transfer
To Next Page
Loading...
