To assign Remote Call Forwarding set
1. Log in to the Message Manager
’s mailbox.
2.
3. Select the desired forwarding setting.
for FWD Busy or No Answer.
for FWD to Outside, then go to step 6.
for FWD Cancel, then go to step 9.
4. Enter the extension number.
5.
to accept the extension number, then go to step 10.
• Enter
to change the extension number, then go to step 4.
6. Enter the desired number.
for telephone number 1, then go to step 8.
for telephone number 2, then go to step 8.
for another telephone number.
• Before you can forward your calls to telephone number 1 or 2, you should first store the
telephone numbers you plan on using with this feature.
7. Enter the telephone number
(
, ). (max. 32 digits)
• Make
sure you begin the telephone number with an outside line access number (to seize an
outside line).
8.
to accept, then go to step 10.
• Enter
to change the telephone number, then go to step 6.
9.
to accept.
10. The new settings are transmitted to the system. If the setting has been completed properly, you
will hear: "Call forwarding accepted
" or "Call forwarding is cancelled" as appropriate.
• If the system announces, "Call forwarding not accepted. Please check the destination
number.", the forwarding setting has not been completed properly, possibly because a
nonexistent extension number has been entered as the destination. For more information,
consult your System Administrator.
Setting the Timed Reminder
The
Message Manager can set or cancel the Timed Reminder. The telephone will ring at the set time according
to the set mode (Once/Daily).
• This feature is not available for PSs or S-PSs.
• This
feature is not available when the Message Manager’s extension (assigned for Operator
1 in the Day Mode) is "default". In this case, it should be changed to the operator’s extension
number. For more information, consult your System Administrator.
294 User Manual
2.2.2 Message Manager Features
To Next Page
Loading...
