Panasonic KX-NS1000 - Page 287

1. Log in to the Message Manager
’s mailbox.
2.
2
3.
3
to assign a telephone number.
4. Enter the desired number.
1
to change the first telephone number.
2
to change the second telephone number.
3
to change the third telephone number.
5.
1
to accept.
6. Dial the telephone number.
7.
2
to accept.
8.
1
to change the telephone number.
2
to accept.
3
to review.
4
to add more digits.
5
to insert a pause.
6
to insert a wait for dial tone.
To set device status
For each device, the notification is enabled or disabled according to a preset schedule. The Message Manager
can enable a device according to a schedule. However, the System Administrator must first assign a
destination number to the desired device.
1. Log in to the Message Manager
’s mailbox.
2.
2
2
3. Enter the device number (1
–6).
• Device number 4, 5, or 6 is used to specify a device number that is "Device No. 1, 2, or 3" for
"E-mail/Text Message Device" in Web Maintenance Console.
• If a telephone number has not been assigned to the selected device number 1, 2, or 3, you
cannot set the device status. Refer to "To assign notification numbers" to assign a telephone
number.
4. Select the desired message type.
1
to notify all messages.
2
to notify urgent messages.
5. Select when the device will be used for message notification.
1
for schedule (a notification is sent each time a message is received, but only during the
times programmed by the System Administrator).
2
for continuously.
3
for disable (notifications are not sent).
Customising the Message Manager’s Mailbox
The
Message Manager can customise the Message Manager’s mailbox by changing the following parameters.
– The Message Manager’s mailbox password
– The extension numbers of Operator 1, 2, and 3
User Manual 287
2.2.2 Message Manager Features