Panasonic KX-NS700 - 3.1.2 Settings on the Programming Mode

3.1.2 Settings on the Programming Mode
You can programme features using the programming mode for a PT or PS.
– Setting Features
– Clearing Features
• To exit at any time, lift the handset.
• To enter the programming mode when using a PS, refer to the documentation for your PS.
• For KX-UT series SIP phone users: You cannot programme the following features using a
KX-UT series SIP phone. These features are programmed via Web Maintenance Console.
For more information, consult your System Administrator.
Setting Features
The default settings are shown in bold letters. For later reference, place a check mark in the boxes below to
indicate your customised setting.
Notice
The default value may vary depending on country/area.
Follow
programming
input.
To programme To exit To enter the programming mode
Follow Selection
& Parameter.
Press PROGRAM
or PAUSE.
Press PROGRAM
or PAUSE.
selection &
parameter
programming
input
Press ENTER
or STORE.
Press ENTER
or STORE.
OR
OR OR
OR
PROG.
PROG.
PAUSE PAUSE
Item
Programming
Input
Selection & Parameter
Your extension information
0
0
The display shows your PT or PS’s
extension number.
<Example>
Ext 101
Display Contrast Selection
*1
Preferred display contrast
level from the 4 levels
available
0
1
1
Light
2
Little Light
3
Little Dark
4
Dark
308 User Manual
3.1.2 Settings on the Programming Mode