Panasonic KX-TD308 - Paralleled Telephone Connection

4-106 DPT Features
P 4.2 DPT Features
Paralleled Telephone Connection
A proprietary telephone (PT) can be connected in parallel with a standard telephone.
This feature allows you to set whether the paralleled standard telephone will ring or not,
when an incoming call is received.
To ring or not to ring a paralleled standard telephone
1. Lift the handset or press the SP-PHONE/MONITOR button.
2. Dial the feature number (39).
3. Dial 1 or 0.
- 1 : to ring
- 0 : not to ring
• You hear a confirmation tone and then a dial tone.
• The display shows:
— (when set to ring)
or
— (when not set to ring)
4. Hang up or press the SP-PHONE/MONITOR button.
Conditions
• The default is “Parallel Off (No ring)”.
• The PT can be used to perform normal operations whether or not the standard telephone
is set to ring.
• When receiving a call:
— If standard telephone is set to ring, then both the PT and the standard telephone will
ring except when the PT is in “Handsfree Answerback” mode or Voice-Calling
mode with the “Alternate Calling — Ring/Voice” feature.
— If standard telephone is not set to ring, then only the PT rings. However, the
standard telephone can answer the call.
• When the standard telephone is in use, the display and the indicators of the PT will
work in the same way as if the PT is in use.
• If you go off-hook while your paralleled telephone is in use, the call will switch over to
your telephone, and vice versa.
• The “XDP*” feature is available.
Parallel On
Parallel Off
1
2
3
1
0
or
4
9
3