5-56 Standard Telephone Features
M 5.2 Standard Telephone Features
Calling back the message notification sender
1. Lift the handset.
• You hear dial tone 4*.
2. Dial the feature number (70) and 2.
3. Start talking.
• The message is cleared after the conversation.
Clearing all message notifications by the message receiver
1. Lift the handset.
• You hear a dial tone 4*.
2. Dial the feature number (70) and 0.
3 Dial your (message receiver’s) extension number.
• All messages are cleared.
Conditions
• If multiple message notifications are left at your extension, call back is executed in the
order received.
• The system supports a maximum of 16 simultaneous messages. If you try to set the
17th message, you will hear a reorder tone.
• The Message Waiting ring interval time can be changed by System Programming
(default: 0 - no ring).
• You can select the Message Waiting ring type by System Programming.
* One of the dial tones. Refer to the “Tone List” in the Appendix (Section 7).
Programming References
• System Programming — Installation Manual
[216] Message Waiting Ring Interval Time
[990] System Additional Information, Field (40)
1
2
3
1
2
3
your extension number
To Next Page
Loading...
