Area Values Description
PBX System Data
Version
Versionxxx-xxx Displays the version number of the system
software installed to the PBX.
The first 3 digits are the version number, and the
last 3 digits are the revision number.
PBX Region Code Regionxxx-xxx Displays the region code assigned to the PBX and
Maintenance Console.
The first 3 digits represent the region code
assigned
to the PBX, and the last 3 digits represent
the region code assigned to the Maintenance
Console.
6. Main Screen
Displays the screens selected from 4. System Menu above.
For details, see Sections Section 3 [1] Configuration to Section 13 [11] Maintenance.
Standard Buttons and Elements
There are several standard buttons that are displayed on many screens within the Maintenance Console.
The standard buttons are as follows:
Button Function
OK Implements changes and closes the current screen.
Cancel Abandons changes and returns to the previous screen.
Close Keeps any changes implemented, and closes the current screen.
Apply Implements changes and remains on the same screen.
Refresh Implements changes, updates displayed data, and remains on the
current screen.
Help Displays the relevant help topic for the current screen.
In addition, many screens within the software display a small open folder icon ( ) beside lists of setting
items.
Clicking this icon will collapse part of the list, allowing other items to be displayed. The icon will change
to a closed folder (
).
Clicking the closed folder icon will expand the list again.
2.1.4 Card Status
Certain
tools, utilities and settings require that the target card be set to out-of-service (OUS) or in-service (INS)
status before the operation is carried out. Where required, this is noted in the description of each item. Card
status changes can only be performed when the software is in Interactive mode (see 2.1.1 Starting
Maintenance Console and Software Modes).
• "In service" means that the card is installed correctly in the PBX, and is capable of being used normally.
• "Out of service" means that the card is installed correctly in the PBX, but has been temporarily removed
from use. This allows settings to be modified or software to be upgraded.
• "Fault" means that the card is not installed in the PBX correctly, or is not functioning correctly. For more
information, see the Installation Manual.
24 PC Programming Manual Document Version 2008-11
2.1.4 Card Status
To Next Page
Loading...
