Panasonic KX-TDA200 - Page 494

Feature Manual References
10.1.3 Line Preference—Outgoing
Incoming Preferred Line
Selects the line on which an incoming call is answered after going off-hook.
Note
that even if a specific PDN button is selected here, a call ringing at any PDN button on the extension will
be answered when going off-hook.
Default
Ringing Line
Value Range
No Line: No line is selected. Select a line by pressing the desired Line Access button to answer a call.
Ringing Line: The longest ringing call is selected.
PDN (KX-TDA100/KX-TDA200/KX-TDA600 only): The call arriving at any PDN button is selected.
F-1–F-36: The call arriving at a flexible button (F-1–F-36) is selected. A flexible button customized as a
Single-CO, Group-CO, Loop-CO, or ICD Group button must be selected.
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
6.5 [4-1-4] Wired Extension—Flexible Button
Feature Manual References
10.1.2 Line Preference—Incoming
Call Waiting Tone Type
Selects the type of Call Waiting tone sent to the busy extension.
Default
CW Tone 1
Value Range
CW Tone 1, CW Tone 2
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
None
Feature Manual References
3.1.10 Call Waiting Tone
494 PC Programming Manual Document Version 2008-11
6.1 [4-1-1] Wired Extension—Extension Settings