KX-TDA50
File Name Description
DSSYS Main system data file. Contains all of the current configuration data for
the PBX.
DSSYS_S Backup main system data file
PSMPR PBX program file. Contains the software to run the MPR board of the
PBX.
PSMPR_S Backup PBX program file
KX-TDA100/KX-TDA200
File Name Description
DSYS Main system data file. Contains all of the current configuration data for
the PBX.
DSYS_SUB Backup main system data file
PMPR PBX program file. Contains the software to run the MPR board of the
PBX.
PMPR_SUB Backup PBX program file
KX-TDA600
File Name Description
DLSYS Main system data file. Contains all of the current configuration data for
the PBX.
DLSYS_S Backup main system data file
PLMPR PBX program file. Contains the software to run the EMPR board of the
PBX.
PLMPR_S Backup PBX program file
When new DSYS/DSSYS/DLSYS and PMPR/PSMPR/PLMPR files are transferred from a connected PC to
the SD memory card using the File Transfer PC to PBX (SD Card) utility (see 2.6.2 Utility—File Transfer
PC to PBX (SD Card)), they are stored as the backup files. To use these files on the PBX, it is necessary to
first swap them with the currently active files on the SD memory card.
Requirements
• This utility only functions on PBXs version 1.005 and later.
• On earlier versions, the reset request confirmation screen will be displayed, and files will not be updated.
To update system files and reset the PBX
1. From the Utility menu, point to System Reset and then click Reset by the Command.
2. Choose whether to back up current system data or not.
• Click SD Backup to back up the current system data to the SD memory card before proceeding.
Select this if you intend to use the current system data unchanged after reset.
• Click Skip to continue without backing up.
Select this if you intend to replace the current system data with data that was uploaded from the PC.
Document Version 2008-11 PC Programming Manual 57
2.6.17 Utility—System Reset—Reset by the Command
To Next Page
Loading...
