Panasonic KX-TDA200 - Page 707

TRG 01–TRG 64 (KX-TDA50/KX-TDA100/KX-TDA200), or TRG 01–TRG 96
(KX-TDA600)
Enables each trunk group for each carrier. If a cell is highlighted in blue, that trunk group is enabled for use
with that carrier.
Default
Trunk groups 01–04: ON
All other trunk groups: OFF
Value Range
OFF (white), ON (blue)
Maintenance Console Location
10.6 [8-5] Carrier
Programming Manual References
None
Feature Manual References
1.1.3 ARS (Automatic Route Selection)
Authorization Code for Tenant
Specifies an Authorization code for each tenant. The Authorization codes can be added to the user-dialed
number by specifying "A" command in
Modify Command on the Carrier tab.
Authorization Code for Tenant—Tenant 1–Tenant 32
Specifies the Authorization code of each carrier for each tenant.
Note
For the KX-TDA50/KX-TDA100/KX-TDA200, only up to 8 tenants are available.
Default
Not stored.
Value Range
Max. 16 digits (consisting of 0–
9, *, and #)
Maintenance Console Location
10.6 [8-5] Carrier
Programming Manual References
None
Document Version 2008-11 PC Programming Manual 707
10.6 [8-5] Carrier