Panasonic KX-TDA200 - Page 380

the call is received, depending on the CTI software used. In Third Party Call Control, the PC does not
control extensions directly.
PBX
CTI
Interface
CTI Server
PC
PC
LAN
LAN or USB
Conditions
[General]
• Capable telephone:
DPT: KX-DT300 series or KX-T7600 series PT, USB module
IP-PT
• CTI
application
software must be installed on the connected PC. In addition, some features may require a
KX-TDA6920, KX-TDA0920, or KX-TDA3920 SD Memory Card for Software Upgrade to Enhanced
Version.
• When using an IP-GW4 card, the firmware (not LPR software) of the card must be version 1.400 or later.
• Application Programming Interface (API)/Protocol
The following interfaces are required for First Party Call Control and Third Party Call Control:
Type
API/Protocol
First Party Call Control
• TAPI 2.1
Third Party Call Control
• ECMA CSTA Phase 3
• TAPI 2.1
• The operating system of PC or CTI Server required for First Party Call Control or Third Party Call Control
depends on
your CTI application software. For details, refer to the manual for your CTI application software.
• Third Party Call Control cannot be performed when two or more CTI servers are connected to the PBX.
[IP-PT Call Control]
• A PC connected directly to an IP-PT cannot be used for First Party Call Control.
• IP-PTs do not support the use of PC Phone or PC Console software on a connected PC.
Installation Manual References
KX-TDA30
2.3.8 IP-GW4 Card (KX-TDA3480)
2.6.4 First Party Call Control CTI Connection
2.11.1 Connection of Peripherals
380 Feature Guide
1.32.1 Computer Telephony Integration (CTI)