Panasonic KX-UT133

Setting Description Value Range Default
DNS Select whether the DNS server
information should be obtained
automatically (i.e., provided by the
DHCP server) or if you will specify it
manually.
If you select "Manual", see "DNS1"
and "DNS2" below.
Manual, Automatic Automatic
DNS1
*1
(Manual DNS
only)
Enter the IP address of the primary
DNS server.
xxx.xxx.xxx.xxx —
DNS2
*1
(Manual DNS
only)
Enter the IP address of the
secondary DNS server.
If a secondary DNS server is not
required, leave this item blank.
xxx.xxx.xxx.xxx —
When STATIC is selected
IP Address
*1
Enter the IP address to assign to the
unit.
xxx.xxx.xxx.xxx —
Subnet mask
*1
Enter the subnet mask for your
network.
xxx.xxx.xxx.xxx —
Default Gateway
*1
Enter the IP address of the default
gateway for your network.
xxx.xxx.xxx.xxx —
DNS1
*1
Enter the IP address of the primary
DNS server.
xxx.xxx.xxx.xxx —
DNS2
*1
Enter the IP address of the
secondary DNS server.
If a secondary DNS server is not
required, leave this item blank.
xxx.xxx.xxx.xxx —
LLDP-MED
*3*4
Configure the LLDP-MED settings. — —
On/Off Enable or disable the "LLDP-MED"
setting.
On, Off On
Timer Specify the LLDP Interval timer. 1–3600 seconds 30
PC port (KX-UT123/
KX-UT133/KX-UT136/
KX-UT248 only)
Specify the necessary settings for
using a PC over a VLAN.
— —
VLAN ID Specify the VLAN ID. 0–4094 0
Priority Specify the priority of packets sent
from this unit.
0–7 0
VLAN Configure the VLAN (Virtual LAN)
settings.
— —
50 Operating Instructions Document Version 2013-03
Customising the Telephone