Panasonic KX-UT133

Setting Description Value Range Default
Enable VLAN Select whether to enable the VLAN
functionality.
Yes, No No
IP Phone Specify the necessary settings for
using the phone features over a
VLAN.
— —
VLAN ID Specify the VLAN ID. 1–4094 2
Priority Specify the priority of packets sent
from this unit.
0–7 7
PC (KX-UT123/
KX-UT133/KX-UT136/
KX-UT248 only)
Specify the necessary settings for
using a PC over a VLAN.
— —
VLAN ID Specify the VLAN ID. 1–4094 1
Priority Specify the priority of packets sent
from this unit.
0–7 0
Speed/Duplex Select the connection mode
(combination of link speed and
duplex
mode) of the LAN port and PC
port.
— —
LAN port
*2
Select the connection mode of the
LAN port.
Auto, 10M-Full,
10M-Half,
100M-Full,
100M-Half
Auto
PC port
*2
(KX-UT123/
KX-UT133/KX-UT136/
KX-UT248 only)
Select the connection mode of the
PC port.
Auto, 10M-Full,
10M-Half,
100M-Full,
100M-Half
Auto
Embedded web
*3
Enable or disable Web User
Interface Programming.
On, Off Off
Authentication Configure the HTTP authentication
ID and password
*5
— —
ID Enter the authentication ID. Max 64 characters
*6
Not stored.
Password Enter the authentication password. Max 64 characters
*6
Not stored.
*1
Press [ ] and [ ] to switch between these items.
*2
The
KX-UT248 supports Gigabit Ethernet. When connecting to a network that supports Gigabit Ethernet, select "Auto". For details,
consult your administrator or dealer.
*3
This setting is not available if KX-UT113/KX-UT123/KX-UT133/KX-UT136 is connected to a KX-NS1000 PBX.
*4
LLDP: Link Layer Discovery Protocol, MED: Media Endpoint Discovery
*5
After these settings are changed, the phone will reboot automatically.
Document Version 2013-03 Operating Instructions 51
Customising the Telephone