Panasonic KX-UTG 300B

36 | Page
© Nextiva, All Rights Reserved
Basic Phone Usage
Making a Call
NOTE: In this guide off-hook is used to describe when a phone is in use, or has a dial tone before
a call is made. On-hook describes when a phone is idle.
1. Go off-hook, or press the SP-PHONE or HEADSET button.
NOTE: You can also initiate a call by pressing the New Call softkey at the bottom of the screen
while the phone is idle (not in use). After doing so, you hear a dial tone through the
speakerphone (Figure 5-1).
Figure 5-1: New Call
2. Dial the phone number or extension of the party you want to call, and then press the Send
softkey at the bottom of the screen (Figure 5-2).
NOTE: If you dial the full 10-digit number of the party you want to call, the Panasonic KX-UTG
300B will automatically start dialing so pressing the Send softkey is not necessary.
Figure 5-2: Send Softkey