Panasonic KX-UTG 300B

38 | Page
© Nextiva, All Rights Reserved
3. Dial the phone number or extension of the party you want to call, and then press the Send
softkey at the bottom of the screen. After you are connected to the second party, both calls will
appear on the screen, with the active call highlighted in blue (Figure 5-5).
NOTE: If you dial the full 10-digit number of the party you want to call, the Panasonic KX-UTG
300B will automatically start dialing so pressing the Send softkey is not necessary.
Figure 5-5: Second Phone Call
4. To go back to the first party, press the corresponding entry on the screen. The second party is
automatically put on hold and you will be speaking to the first party again (Figure 5-6).
Figure 5-6: Selecting Active Calls