Basic
- 44 -
• Press the shutter button halfway or turn the camera off and on to cancel [Sleep Mode].
• [Sleep Mode] is set to [5MIN.] in the Intelligent Auto Mode.
• [Sleep Mode] does not work in the following cases.
– When using the AC adaptor
– When connecting to a PC or a printer
– When recording or playing back motion pictures
– During a slide show
– [Auto Demo]
• The effect of the [LCD Power Save] is lower in the Digital Zoom range compared to the Optical
Zoom range.
• The effect of the [LCD Power Save] will not affect the image being recorded.
• Setting of [LCD Mode] has priority over the setting of [LCD Power Save] regarding the
brightness of the LCD monitor.
• [Auto Review] is activated regardless of its setting in the following cases.
– In [Handheld Night Shot], [Hi-Speed Burst] and [Flash Burst] in scene mode
– When using Auto Bracket
– During the Burst Mode
• In Intelligent Auto Mode or [Photo Frame] in Scene Mode, the Auto Review function is fixed to
[2 sec.].
• [Auto Review] does not work when recording motion pictures.
[Economy]
You can conserve the battery life by setting these menus.
Also, the battery life is conserved by dimming the LCD monitor.
[
p] ([Sleep Mode]):
The camera is automatically turned off if the camera has not been
used for the time selected on the setting.
[ ] ([2MIN.])/[ ] ([5MIN.])/[
] (
[10MIN.])/[ ] ([Off])
[] ([LCD Power Save]):
Brightness of the LCD monitor is lowered. The battery life will be
conserved by lowering the image quality of the LCD monitor
further during the recording
¢
.
¢ Excluding the Digital Zoom range.
[ON]/[OFF]
[Auto Review]
Set the length of time that the picture is displayed after taking the
still picture.
[ ] ([1 sec.])
[ ] ([2 sec.])
[
] ([Hold]):
The pictures are displayed until [Exit] is touched.
[
] ([Off])
To Next Page
Loading...
Need help?
General
