Taking Pictures using
Burst Mode
| Press and hold the burst mode
button.
©
2 Press A/T to select a mode.
A
Y
or
• You can also use the single or burst
mode button to select.
3 Press [MENU/SET].
• You can also press the shutter
button halfway or press the center of
the joystick to finish.
• The menu screen disappears after
about 5 seconds. At this time, the
selected item is automatically set.
4 Take a picture.
*Hold down the shutter button fully to
activate the burst mode.
Advanced (Recording pictures)
• Number of pictures recorded in burst
mode
Burst speed Number of recordabJe
(pictures/ pictures (pictures)
second) ' []
3
max. 5 max.7
2
Depends on the
approx. 2 remaining capacity of the
built-in memory/card.
The burst speed constant regardless
of the transfer speed of the card.
• The number of pictures indicated is when
the shutter speed is faster than 1/60 and
the flash is not activated.
• The burst speed (pictures/second) may
become slower depending on the
recording environment such as in dark
places or if the ISO sensitivity is high.
• If you take pictures in burst mode with the
built-in memory, it will take time to write
the picture data.
• In simple mode [V], the settings become
as follows. [@] appears on the left of the
screen. (P120)
- [_ ENLARGE]:
_/Max. 5 pictures
- [!_ 4" X 6"/10x 15cm]/[_ E-MAI L]:
N/Max. 7 pictures
*When the flash is activated, you can
take only 1 picture.
• When the burst mode setting is set to
Unlimited
-The burst speed becomes slower
halfway. The exact timing of this
depends on the type of card, the picture
size and the quality.
-You can take pictures until the capacity
of the built-in memory or the card is full.
.The focus is fixed when the first picture is
taken.
51
VQT 1B25
To Next Page
Loading...
