Attaching the Lens
Cap/Strap
• Lens Cap (supplied)
Preparation
• Strap (supplied)
] Pass the strap through the hole at
the strap eyelet.
] Pass the string through the hole
on the lens cap.
2 Pass the same string through the
hole on the camera.
2 Pass the strap through the
stopper and fasten the strap.
_,_: Pull the strap 2 cm or more.
3 Attach the lens cap ..........................................................................................................................................................................................................................................................................
• Attach the strap to the other side of the
camera being careful not to twist it.
• Check that the strap is firmly attached to
the camera.
• Attach the strap so that the "LUMIX" LOGO
is on the outside.
• When you turn the camera off, carry the
camera or play back the pictures, attach
the lens cap to protect the surface of the
lens.
• Detach the lens cap before turning on the
camera in the recording mode.
• Be careful not to lose the lens cap.
11
VQT 1B25
To Next Page
Loading...
