Manual exposure
[]
Determine the exposure by manually
setting the aperture value and the shutter
speed.
| Tilt the joystick towards AlVl411
I_ to set the aperture value and
the shutter speed.
Set the aperture value and
the shutter speed.
Switch between the aperture
value and the shutter speed.
2 Press the shutter button halfway.
*The manual exposure assistance _'_,)
appears for about 10 seconds to
indicate the exposure.
*Set the aperture value and the shutter
speed again when the exposure is not
adequate.
Advanced (Recording pictures)
3 Take the picture.
• Manual Exposure Assistance
The exposure is
adequate.
Set to faster shutter
speed or larger aperture
value.
Set to slower shutter
speed or smaller
aperture value.
• The manual e> )osure assistance is an
approximation. We recommend checking
the pictures after taking them using the
review function.
• Refer to P58 for the available aperture
values and the shutter speed.
• The brightness of the screen may differ
from the brightness of the actual pictures.
Check the pictures using the review
function or playback mode.
• If the exposure is not adequate, the
aperture value and the shutter speed turn
red when the shutter button is pressed
halfway.
• You cannot set the following items in
manual exposure.
-Slow sync./Red-eye reduction [_]
(P43)
-[AUTO] in ISO sensitivity (P79) (The ISO
sensitivity is automatically set to
[ISO 100] when you switch from [AUTO]
to Manual exposure.)
-Exposure compensation (P48)
57
VQT 1B25
To Next Page
Loading...
