Preparation
Attaching the Lens
Hood
In bright sunlight or backlight, the lens hood
will minimize lens flare and ghosting. The
lens hood cuts off excess lighting and
improves the picture quality.
• Check that the camera is turned off.
• Close the flash.
3 Tighten the screw.
| Attach the hood adaptor
(supplied). • Do not tighten the screw too much.
• Removing the hood adaptor
• Do not tighten the hood adaptor too
much.
2 Place the camera upside down,
align the mark on the lens hood
with the mark _) on the camera
and then insert the lens hood.
• Hold the edge of the hood adaptor to
remove it.
• Check if the screw is loose and then
attach the lens hood.
12
VQT1 B25
To Next Page
Loading...
