54
Recording
VQT4M51 (ENG)
∫ Focusing in Burst Mode
¢1 When the subject is dark or the burst speed is set to [SH], the focus is fixed on the first
picture.
¢2 The burst speed may become slower because the camera is continuously focusing on the
subject.
¢3 Burst speed takes priority, and focus is estimated within possible range.
Taking Pictures using Auto Bracket
Applicable modes:
Maximum of 7 pictures will be recorded with different exposure settings following the
Exposure Compensation range every time the shutter button is pressed.
1
Set the drive mode dial to [ ].
2
Focus on the subject and take a picture.
A Auto Bracket indication
• If you press and hold the shutter button, the number of pictures that
you set is taken.
• The Auto Bracket indication blinks until the number of pictures that you set is taken.
• The picture count is reset to [0] if you change the Auto Bracket setting or turn the
camera off before all the pictures that you set are taken.
∫ Changing the settings for [Single/Burst Settings], [Step] and [Sequence] in Auto
Bracket
1 Select [Auto Bracket] in the [Rec] menu. (P23)
2 Press 3/4 to select [Single/Burst Settings], [Step] or [Sequence] and then
press 1.
3 Press 3/4 to select the setting and then press [MENU/SET].
•
Exit the menu after it is set.
Focus Mode
Focus/Release
Priority
Focus
AFS
[FOCUS]
At the first picture
[RELEASE]
AFF/AFC
¢1
[FOCUS]
Normal focusing
¢2
[RELEASE]
Predicted focusing
¢3
MF — Focus set with Manual Focus
AFS
DMC-GH3A&GH3H&GH3EB_VQT4M51_eng.book 54 ページ 2012年10月25日 木曜日 午後5時25分