74
Wi-Fi
VQT4M51 (ENG)
1 Press [Wi-Fi].
2 Press 3/4 to select [New Connection], and then press [MENU/SET].
•
When connecting with the setting you used before, you can select the connection
destination from [Select a destination from History] (P62) or [Select a destination from
Favorite]. (P62)
3 Press 3/4 to select [Send Images Stored in the Camera], and then press
[MENU/SET].
4 Press 3/4 to select [AV device], and then press [MENU/SET].
5
Press
3
/
4
to select [Home] or [External], and then press [MENU/SET].
6 Press 3/4 to select connection method, and then press [MENU/SET].
•
When [External] is selected, the screen for setting a wireless access point is displayed.
(P63)
7 Press 3/4 to select a device you want to connect, and then press [MENU/SET].
•
When the connection is complete, the screen is displayed. To change the send setting,
press [DISP.].
8 Press 3/4 to select [Single Select] or [Multi Select] and then press [MENU/
SET].
•
To change the setting or disconnect, press [Wi-Fi].
9 Select and send the images.
When sending images to AV device
Preparations:
When sending a picture to [Home], set your device to DLNA waiting mode.
•
Read the operating instructions of your device for details.
When sending images to [External], the following are required:
•
Registration to “LUMIX CLUB”.
• Address number and access number acquired by the destination External AV device.
[Via Network]
When you want to connect to an AV device via a wireless access
point. (P63)
[Direct]
When you want to directly connect an AV device to this unit with
[Wi-Fi Direct], [WPS Connection], or [Manual Connection]. (P65)
DMC-GH3A&GH3H&GH3EB_VQT4M51_eng.book 74 ページ ２０１２年１０月２５日 木曜日 午後５時２５分
To Next Page
Loading...
