64
Wi-Fi
VQT4M51 (ENG)
Search for available wireless access points.
• Confirm encryption key of the selected wireless access point if the network authentication is
encrypted.
• When connecting by [Manual Input], confirm SSID, encryption type, encryption key of the
wireless access point you are using.
1 Press 3/4 to select the wireless access point you are
connecting to, and press [MENU/SET].
•
Touching [DISP.] will search for a wireless access point again.
• If no wireless access point is found, refer to “When connecting
with [Manual Input]
” on P64.
2 (If network authentication is encrypted)
Enter the encryption key.
∫ When connecting with [Manual Input]
1 On the screen displayed in step 1 of “If you are not sure
about the WPS compatibility (connecting by [Manual
Connection])”, select [Manual Input] by pressing 3/4, then press [MENU/SET].
2 Enter the SSID of the wireless access point you are connecting to, then select
[Set].
3 Press 3/4 to select the network authentication type, and press [MENU/SET].
•
For information on network authentication, see the manual of the wireless access point.
4 Press 3/4 to select the encryption type, and press [MENU/SET].
•
The type of settings that can be changed may vary depending on the details of network
authentication settings.
5 (When an option other than [No Encryption] is selected)
Enter the encryption key and select [Set].
If you are not sure about the WPS compatibility (connecting by [Manual
Connection])
Network authentication type Encryption types that can be set
[WPA2-PSK]/[WPA-PSK] [TKIP]/[AES]
[Common Key] [WEP]
[Open] [No Encryption]/[WEP]
DMC-GH3A&GH3H&GH3EB_VQT4M51_eng.book 64 ページ ２０１２年１０月２５日 木曜日 午後５時２５分
To Next Page
Loading...
