- 15 -
English
ProΙΙ
A
B
C
D
PROG
PROG
BUZZ
Digital Display Window
Power Level Indicator Display
Power Level Selector Dial
Timer Dial
Start Button
Door Handle
Oven Lamp Cover
Air Filters
Program Entry Switch
(behind Air Filter)
Buzzer Switch (behind Air Filter)
Middle Shelf
A — Program Display
B — Beep Tone Mode Display
C — Heating Time Display (min. sec.)
D — Power Level Indicator
HIGH
MEDIUM
LOW
DEFROST
How to Operate NE-3240/NE-2140/NE-1840
A. MANUAL HEATING
Example: To cook food at HIGH power for 2 minutes
PAD INSTRUCTION
DIGITAL DISPLAY WINDOW
1
Open the door and put the food in the oven.
The oven lamp will turn on. “0” and Power Level Indicator will
appear.
2
Select the desired Power Level by turning the Power Level
Selector Dial.
3
Set the desired heating time.
Please check the heating time will appear.
Note: up to 60 minutes.
4
Press Start Button.
The oven lamp will turn on and heating will start. Power Level
Indicator will start to blink, and heating time will count down.
• At the end of the time, the beep tone will sound and all heating will stop. The oven
lamp will go off. 1 minute later the cooling fan will stop. The display will blink “0” until
the door is opened.
• Open the door and take the food out. “0” will appear in the display window and the
Power Level will be displayed. The oven lamp will be turned on.
• Close the door. The oven lamp will go off and 1 minute later the display window will go blank.
• When you press the Start Button with door open, “0” will appear in the display in all cases.
• Even after setting the heating time you can still change the power level.
• If you wish to change the heating time during heating, simply adjust the timer to desired
minutes and seconds. The microwave oven can also be turned OFF by turning the
Timer Dial to the left until “0” appears in the digital display and beep tone can be heard.
Outline Diagram of NE-3240/NE-2140/NE-1840
To Next Page
Loading...
