Panasonic NE-1840 - Beep Tone

- 23 -
English
How to Operate NE-1880
X To Release Program Lock:
PAD INSTRUCTION DIGITAL DISPLAY WINDOW
1
Keep the door closed.
 Digital Display Window must be blank.
2
PROG LOCK
Press Program Lock Switch until “PROG” and “P” appear.
(for five seconds)
 “PROG” and “P ” will appear.
PROG
In Program Unlock mode:
• Oven reverts to a two-touch operating mode (Memory pad + Start pad).
• Repeat and interrupt feature are operational.
• Memory pads can be programmed.
• Tone loudness control and length control are operational.
E. BEEP TONE
The loudness of beep tone and the length of beep tone at the end of heating cycle can be set.
There are four levels of the loudness.
There are two options of the length of beep tone at the end of heating cycle.
The loudest level and 3 beeps are preset at the factory.
X To Select Loudness Level and Length “3 beeps”:
PAD INSTRUCTION DIGITAL DISPLAY WINDOW
1
PROG
Press Program Entry Switch.
 “PROG” sign will start to blink in the display window. (The door may
be open or closed at this stage)
PROG
2
BUZZ
Press Buzzer Switch.
 The tone will sound at its loudness level and the loudness level “3”
followed by the word “bEEP” will appear. “PROG” will start to blink
and 1st Stage Heating Indicator “1” (the length of beep tone
“3 beeps”) will be indicated.
Note: Repeating to press Buzzer Switch will lower the loudness level
all the way to silent. (3bEEP –– loudest, 2bEEP –– middle,
1bEEP –– quietest, and 0bEEP –– silent)
1
PROG
3
PROG
Press Program Entry Switch again.
 “PROG” will stop blinking. That means that you have completed
program.
Three seconds later, the display window will go blank when the
door is closed.
1
PROG