- 22 -
How to Operate NE-1880
X 2 or 3 stages heating
THE OVEN CAN NOT BE PROGRAMMED WHEN PROGRAM LOCK IS ACTIVATED! (see pages 22–23)
DO NOT OPEN THE DOOR WHILE PROGRAMMING!
Example: To program cooking at DEFROST power for 1 minute and at HIGH power for 2 minutes into Memory pad “5”
”
PAD INSTRUCTION
DIGITAL DISPLAY WINDOW
Follow steps 1 to 5 on page 21.
1
A
PROG
6
Press Power Level Selector pad once.
The power level for 2nd stage will be indicated, 2nd Stage Heating
Indicator “2” will start to blink.
1
A
2
PROG
7
Set the desired heating time using Timer Dial.
The set heating time will appear.
Note: up to 15 min. on or , 60 min. on , or
1
A
2
PROG
8
PROG
Press Program Entry Switch again.
“PROG” and 2nd Stage Heating Indicator “2” will stop blinking. The
total time for both stages will appear. This means that you have
completed programming.
1
A
2
PROG
• Three seconds later, Digital Display Window will go blank.
D. PROGRAM LOCK
X To Activate Program Lock:
PAD INSTRUCTION
DIGITAL DISPLAY WINDOW
1
Keep the door closed.
Digital Display Window must be blank.
2
PROG LOCK
Press Program Lock Switch until “PROG”, “P” and “L” appear.
(for five seconds)
“PROG”, “P” and “L” will appear.
PROG
In Program Lock mode:
• The oven is started by pressing the desired Memory pad. There is no need to press Start pad.
• Opening the door cancels the remaining time on the program.
• The oven can not be programmed until the program lock is released.
To Next Page
Loading...
