Panasonic NV-RX11A - Using the Memory Stop Function.48

Using the Memory Stop Function
This function is convenient for temporarily marking a
tape position during recording or playback so that you
can easily find it again later for playback. j
1 Press the [RESET] Button during
recording or playback at the desired |
tape position to reset the Elapsed Tape
Time Indication to [0:00.00]. ]
2 Press the [MEMORY] Button so that the
Memory Stop Indication [M] O appears
in front of the Elapsed Tape Time
Indication.
•[M] means Memory. i
3 During playback:
Press the [STOP] Button to stop
playback. -
During recording:
Press the Recording Start/Stop Button
to switch the Movie Camera over to the
Recording Pause Mode.Then, press the
[VCR/CAMERA] Button to switch the
Movie Camera over to the VCR Mode
(the [VCR] Lamp lights.)
4 Press the [ ►► ] or [ ◄ ◄ ] Button.
•The tape automatically stops approximately at the t
[M0:00.00] position.
5 Press the [PLAY] Button to start j
playback. I
48