Panasonic Palmcoder PalmSight PV-L51 - Page 15

Built-in Auto Light
Usine he Uri Before you begin...
SEE « Connect Camcorder to power source.
For recording in dim lighting. + Set POWER to CAMERA.
Set LIGHT to AUTO.
Light turns on/off automatically according
to lighting conditions.
Or, set LIGHT to ON/OFF manually.
1X RC E O] SP
á l
=D appears in EVF or
LCD monitor when
Light is on.
Note:
e Using Light reduces battery operating time.
+ Provide proper ventilation when using
Light extensively in a hot environment.
e Using Light when the Camcorder is
powered by a car battery may shorten bulb Caution:
life. Light becomes hot. Never cover Light
s Set Light to OFF when not in use. while on.
[Sian
Eme
to
Eula
|
Before
you
begin...
©)
G
D
~)
D
Ee
©)
5
+ Order Part No. VULS0001 (VLLW0015 and
1 cushions) for replacement bulb unit.
s Set POWER to OFF.
$
1 Press in on both sides of lens cover
and pull straight out and off.
2 Using Tweezers or needle-nose
pliers, carefully remove bulb.
* Take unit to service center if you need
assistance.
3 Replace bulb using a clean cloth or
tissue. (Do not touch with fingers.)
4 Replace lens cover.
Note:
s Handle bulb gently. Excessive force may
cause bulb to crack.
DANGER:
Use only replacement bulb (PART NO. VLLW0015) supplied by Panasonic to reduce
risk of fire.
Handle new bulb with cloth or tissue as skin oils will decrease bulb life.
Remove lens cover and allow bulb to cool before replacing to avoid possible burn
hazard.
15