Supplying Power
POWER
Lamp
CHARGE
Lamp
1
1
2
3
Plug in AC Adaptor.
POWER Lamp lights,
Insert Batter3G.
O Align right side of Battery with line
on AC Adaptor.
_) Press Battery down and slide in
direction of arrow.
CHARGE Lamp lights and then goes
out when charging is done (approx.
1 and 1/2 hours).
Remove Battery
Slide Battery out and off.
Note:
After recharging 5 times, use BATTERY
REFRESH feature as explained on page t3.
• Battery life gradually decreases after
repeated use and recharging. If operation
time becomes very short, even after a
sufficient charge, discard Battery properly
(page 13),
A fully charged Battery provides a maximum of about 2 hours of continuous use (LCD
monitor off) or about 1.5 hours (LCD monitor on). Actual time may vary due to operating
conditions. Using the Built-in Light decreases operating time.
2
1
2
Attach Battery
Align Battery with top of mounting
surface.
_) Press and snap into place.
Remove Battery
While sliding BATTERY RELEA_I_,
remove Battery.
To Next Page
Loading...
