Panasonic Palmcorder Palmsight PV-L750 - Copying your Tapes (dubbing); Connections; Monitor with your TV

Copying your Tapes (dubbing)
............ _.. I,%J.__ .......... ,,,,,,,,,,,,,,,,,,,uJ,,l± _ _ I
Before you begin...
- Make Camcorder-VCR connections
(see left).
• Turn both units
on.
ying) / _ • Set VCR input signal to LINE,
Please see VCR owner's manual,
vu,HuuuurS°UrCer(Pla .Set Camcorder POWER to VCR.
1 Insert a pre-recorded tape
_"----------------_ into Camcorder and a blank tape with
_'_._'--_ _ _ record tab into VCR.
ttltl 2 PressPLAYon Camcorder, then
IIIB IIpress ST-_-L at starting point,
Press REC, then STILL/PAUSE on
o VCR, -- -
Press STILL on Camcorder and
/ VHF Connecting .........._ STIL_PAUSE on VCR again to start
_" Cable (not supplied) ---_. copying.
{ Recording:
,// VCR % _,/ Press STOP on both units to stop
copying.
.o,o
To Audio--_-To Video • Camcorder will only playback tapes
recorded in SP or SLP mode.
yln , Dubbing may reduce picture quality.
Audio/Video Cable
(supplied)
• Turn TV on and tune to VCR
channel (CH3 or CH4).
, Set TV/VCR Selector on VCR to VCR.
t CAUTION:
nauthorized exchanging and/or /
opying of copyrighted recordings mayi
e copyright infringement. /
,/
33